/* 
   Important constants for tuning kb1 echo can
 */
#ifndef _MEC2_CONST_H
#define _MEC2_CONST_H


/* Convergence (aka. adaptation) speed -- higher means slower */
#define DEFAULT_BETA1_I 2048

/* Constants for various power computations */
#define DEFAULT_SIGMA_LY_I 7
#define DEFAULT_SIGMA_LU_I 7
#define DEFAULT_ALPHA_ST_I 5 		/* near-end speech detection sensitivity factor */
#define DEFAULT_ALPHA_YT_I 5

#define DEFAULT_CUTOFF_I 128

/* Define the near-end speech hangover counter: if near-end speech 
 *  is declared, hcntr is set equal to hangt (see pg. 432)
 */
#define DEFAULT_HANGT 600  		/* in samples, so 600 samples = 75ms */

/* define the residual error suppression threshold */
#define DEFAULT_SUPPR_I 16		/* 16 = -24db */

/* This is the minimum reference signal power estimate level 
 *  that will result in filter adaptation.
 * If this is too low then background noise will cause the filter 
 *  coefficients to constantly be updated.
 */
#define MIN_UPDATE_THRESH_I 4096

/* The number of samples used to update coefficients using the
 *  the block update method (M). It should be related back to the 
 *  length of the echo can.
 * ie. it only updates coefficients when (sample number MOD default_m) = 0
 *
 *  Getting this wrong may cause an oops. Consider yourself warned!
 */
#define DEFAULT_M 16		  	/* every 16th sample */

/* If AGGRESSIVE supression is enabled, then we start cancelling residual 
 * echos again even while there is potentially the very end of a near-side 
 *  signal present.
 * This defines how many samples of DEFAULT_HANGT can remain before we
 *  kick back in
 */
#define AGGRESSIVE_HCNTR 160		/* in samples, so 160 samples = 20ms */

/* This knob controls the number of passes the residual echo supression 
 * algorithm makes.
 */
#ifdef AGGRESSIVE_SUPPRESSOR
 #define RESIDUAL_SUPRESSION_PASSES 2
#else
 #define RESIDUAL_SUPRESSION_PASSES 1
#endif

/* If defined then agressive echo cancellation will only be used for
 * this amount of time then we will go back to normal cancelation.
 * This is helpful if you have bad echo while training
 */
/* #define AGGRESSIVE_TIMELIMIT 150000 */ /* 8 = 1ms */


/***************************************************************/
/* The following knobs are not implemented in the current code */

/* we need a dynamic level of suppression varying with the ratio of the 
   power of the echo to the power of the reference signal this is 
   done so that we have a  smoother background. 		
   we have a higher suppression when the power ratio is closer to
   suppr_ceil and reduces logarithmically as we approach suppr_floor.
 */
#define SUPPR_FLOOR -64
#define SUPPR_CEIL -24

/* in a second departure, we calculate the residual error suppression
 * as a percentage of the reference signal energy level. The threshold
 * is defined in terms of dB below the reference signal.
 */
#define RES_SUPR_FACTOR -20


#endif /* _MEC2_CONST_H */