Support for Astribanks 116x: tools part

* New USB firmware loading mechanism.
  - Incompatible with previous one: upgrade using fxload or hard reset
  - astribank_hexload is the new low-level loading tool
  - fpga_load remains for backward compatibility.
  - xpp/astribank_upgrade: automate upgrading using fxload
* Much enhanced control protocol ("MPP")
  - astribank_tool is the low-level tool for that.
* Support for the TwinStar (dual USB port)
  - Managed through astribank_tool
  - Wrapper perl modules and scripts provided
* Allow explicit ordering of Astribanks
  - /etc/dahdi/xpp_order - explicit order of Astribanks on the system
  - The default sorter is now to use those and fall back to connectors
    (previous default).
  - An option to dahdi_registration to change sorting.


git-svn-id: http://svn.asterisk.org/svn/dahdi/tools/trunk@6313 a0bf4364-ded3-4de4-8d8a-66a801d63aff

1 files changed, 1 insertions, 9 deletions

diff --git a/xpp/xpp_sync b/xpp/xpp_sync
index e62169a..44f8e39 100755
--- a/xpp/xpp_sync
+++ b/xpp/xpp_sync
@@ -39,7 +39,7 @@ if(@ARGV == 1) {
 sub get_sorted_xpds() {
 	my @good_xpds;
 
-	foreach my $xbus (Dahdi::Xpp::xbuses('SORT_CONNECTOR')) {
+	foreach my $xbus (Dahdi::Xpp::xbuses) {
 		next unless $xbus->status eq 'CONNECTED';
 		foreach my $xpd ($xbus->xpds()) {
 			my $isreg = $xpd->dahdi_registration();
@@ -200,18 +200,10 @@ The parameter it is called with defaults to
 I<auto>, but it is possible to override that parameter (e.g: set it to
 I<dahdi>) through the value of XPP_SYNC in /etc/dahdi/init.conf .
 
-It should be run after dahdi_cfg as the configuration of a PRI module
-is set from it. It must be run after dahdi_registration as it only
-handles XPDs that are registered spans.
-
 =head1 FILES
 
 =over
 
-=item /sys/bus/astribanks/drivers/xppdrv/sync
-
-The low-level interface used by xpp_sync to set / read registration.
-
 =item /proc/xpp/sync
 
 (Deprecated: no longer supported)