diff options
Diffstat (limited to 'xpp')
| -rw-r--r-- | xpp/README.Astribank | 13 | ||||
| -rwxr-xr-x | xpp/xpp_sync | 13 |
2 files changed, 26 insertions, 0 deletions
diff --git a/xpp/README.Astribank b/xpp/README.Astribank index fc3d4df..05c8a74 100644 --- a/xpp/README.Astribank +++ b/xpp/README.Astribank @@ -1112,6 +1112,19 @@ parameter <<_zap_autoreg>> in the modprobe configuration file (A file under options xpp zap_autoreg=1 +Astribanks Synchronization Source +^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ +If there is more than one Astribank on the system, all the Astribanks +keep their clock in sync. Optionally the Astribanks can synchronize +their clock to the master DAHDI device (in case it is a different DAHDI +device). Normally you just use the default init.d script or run +explicitly: + + xpp_sync auto + +(For now see the man page of xpp_sync for more information) + + DAHDI And Above ^^^^^^^^^^^^^^^ From here you get a standard DAHDI span. The next step is to configure diff --git a/xpp/xpp_sync b/xpp/xpp_sync index 8d85739..e62169a 100755 --- a/xpp/xpp_sync +++ b/xpp/xpp_sync @@ -200,14 +200,27 @@ The parameter it is called with defaults to I<auto>, but it is possible to override that parameter (e.g: set it to I<dahdi>) through the value of XPP_SYNC in /etc/dahdi/init.conf . +It should be run after dahdi_cfg as the configuration of a PRI module +is set from it. It must be run after dahdi_registration as it only +handles XPDs that are registered spans. + =head1 FILES =over +=item /sys/bus/astribanks/drivers/xppdrv/sync + +The low-level interface used by xpp_sync to set / read registration. + =item /proc/xpp/sync +(Deprecated: no longer supported) xpp_sync is essentially a nicer interface to /proc/xpp/sync . That file shows the current xpp sync master (and in what format you need to write to it to set the master). +=head1 SEE ALSO + +dahdi_registration(1), dahdi_cfg(1), README.Astribank + =back |