diff options
Diffstat (limited to 'xpp/README.Astribank')
| -rw-r--r-- | xpp/README.Astribank | 10 |
1 files changed, 4 insertions, 6 deletions
diff --git a/xpp/README.Astribank b/xpp/README.Astribank index 17d4fba..af1c690 100644 --- a/xpp/README.Astribank +++ b/xpp/README.Astribank @@ -139,7 +139,7 @@ completed the Vendor ID is e4e4 and the Product ID is 1131. You can use the following command in order to load the "USB" firmware manually: - fxload -t fx2 -D /proc/bus/usb/MMM/NNN -I /usr/share/zaptel/USB_1130.hex + fxload -t fx2 -D /proc/bus/usb/MMM/NNN -I /usr/share/zaptel/USB_FW.hex where, @@ -163,9 +163,9 @@ which is built in the directory xpp/utils and then copied to folder /usr/sbin during Zaptel installation. The command syntax is similar to the syntax of fxload. You can use the -following command in order to load the "USB" firmware manually: +following command in order to load the FPGA firmware manually: - fpga_load -D /proc/bus/usb/MMM/NNN -I /usr/share/zaptel/FPGA_FXS.hex + fpga_load -D /proc/bus/usb/MMM/NNN -I /usr/share/zaptel/FPGA_1151.hex Please note, that NNN value differs from that that was used for the fxload command due to the fact that device has "reconnected" itself @@ -226,12 +226,10 @@ second time for FPGA firmware loading. Firmware Resetting ~~~~~~~~~~~~~~~~~~ Newer versions of the USB firmware can now be reset using 'fpga_load -r'. -This will only work when the device is not used by the driver, so you may -need to run 'rmmod xpp_usb' before. Also you can try the following: - rmmod xpp_usb; /usr/share/zaptel/xpp_fxloader reset + /usr/share/zaptel/xpp_fxloader reset # if asterisk was running: you may need to stop/restart it now. # if there are some "disconnected" spans in /proc/xpp/xbuses # wait a while, until you see the 1152 IDs again, and then: |